JVC PC-X110 User Manual

PC-X110 B/E/G/GI/EN
* To check the timer setting
1, Press the TIMER ON/OFF ( @)) button while pressing
the SHIFT button.
2. When the previous engaged mode is displayed, timer
setting has been completed.
Notes:
© When the timer is set incorrectly or the correct mode is
not selected, perform “Setting the timer” from the
beginning
© When the timer is set, “=
the input digits.
© When the timer stop time is not set, the timer operates
for 2 hours and then the unit is switched off. To continue
listening after the timer stop time, display the timer stop
time, change the hours digits to “-:” using the UP button
and press the ENTER button.
"in the display is replaced by
Timer recording
© The current time must be set correctly before you set
timer recording.
@ Make sure that the erase protection tabs of the cassette
have not been broken off.
Operations
1. Set the POWER button to on,
2. Load a cassette in Deck A.
© Insert the cassette with the side to be recorded
facing out
3. Setthe timer start and stop times, then set the required
volume, in this order. (Refer to “Setting the timer” on
page 46.)
© Set the timer about a minute before the broadcast
to be recorded is scheduled to start.
4. Press the TUNER/BAND button.
© Tune to the station to be recorded. (Refer to page
33.)
Set the POWER button to STANDBY.
Press the © REC and » PLAY buttons of deck
simultaneously.
oe
Note:
Timer recording will start at the preset start time. The
power will not be switched off at the timer-off time during
tape operation, but will be switched off when the tape ends.
* To cancel timer operation
Set the POWER button to on, then press the TIMER
ON/OFF (©) ) while pressing the SHIFT button, so that
the timer mode indicator ( )) goes out.
Ifyou do this, timer recording will not start at the timer start
time.
Note:
Once the timer has been set, the start and stop times, etc.,
are stored in memory. When timer recording or playback is
required at different times, the timer must be set again.
© After setting the timer start and stop times, check that
the unit is tuned to the required frequency.
22 (No. 1904)
Timer playback
@ Timer playback of tapes, broadcasts and CDs is
possible.
Operations
1. Set the POWER button to on.
2. Setthe timer start and stop times, then set the volume,
in this order. (Refer to “Setting the timer” on page 46.)
3. Select the source sound.
[source sound | Timer mode| Operations
CD play cD Load a disc and press the O
STOP/CLEAR button to set
| the CD mode.
Tape playback | TAPE Load a cassette tape.
Radio TUNER Press the TUNER/BAND
broadcast button to set to the tuner
mode and tune to the
required frequency.
© Timer playback of a CD is possible in programmed
order. (See page 27.)
@ The volume can be set to 25 different levels.
4. Switch the power off.
(When performing the timer playback of tape, press the
» PLAY button of the deck.)
© Timer playback will start at the timer start time and the
power will be switched off at the timer stop time. (Tuner
or CD)
The power will not be switched off at the specified time
during tape operation and will be switched off at the
tape end.
The unit remains in the same timer mode even after the
power is switched off and the same timer function will
be repeated at the same time on the following day.

JVC PC-X110 Specifications

General

Brand	JVC
Model	PC-X110
Category	CD Player
Language	English