JVC PC-X110 User Manual

DUBBING (SYNCHRO START DUBBING)
Normal and high-speed dubbing can be done from Deck B
to Deck A.
Operate in the order shown
lee
Recording from the radio
Operate in the order shown
PC-X110 B/E/G/GI/EN
Load a cassette tape in deck A. (Refer to the note on
page 38.)
Load a pre-recorded cassette tape in deck B.
© Slightly press the » PLAY button to set to TAPE
mode. (The button should not be locked.)
Set to NORMAL SPEED or HIGH SPEED.
Set to correspond to the type of tape in Deck B.
Press the 1 PAUSE button.
Press the O REC button with the » PLAY button.
(Record-pause mode.)
Press the PLAY button. (Synchronized dubbing will
start.)
Note
1.
Television
receivers
placed
close
to
this
unit
may
cause
interference
on
the
recorded
signal
when
this
unit
is
used
in
the
high-speed
dubbing
mode.
If
this
happens,
either
turn
off
the
television
receiver
or
use
the
normal-
speed
dubbing
mode.
2.
With
Deck
A
in
the
record-pause
mode,
the
1
PAUSE
button
is
released
when
Deck
B
enters
the
stop
mode.
@ Load a cassette. (Deck A)
Press the TUNER/BAND button.
Tune to the required station.
@ Press the © REC button with the m PLAY button.
© To stop recording temporarily, press the i» PAUSE
button. To resume recording, press the | PAUSE
button again.
Erasing
When recording on a pre-recorded tape, the previous
recording is automatically erased and only the new material
can be heard when the tape is played.
To erase a tape without making a new recording ...
Slightly press the » PLAY button of the deck to set to the
TAPE mode and press the O REC and » PLAY buttons
together after pressing the stop button.
(No. 1904) 19

JVC PC-X110 Specifications

General

Brand	JVC
Model	PC-X110
Category	CD Player
Language	English