EN
REMOTE CONTROL OPERATION
To operate the unit with the remote control, point the remote handset at the remote sensor on
the front panel and press the appropriate button on the remote handset.
The remote works best within a range of 6 ~ 7 meters from the front panel and on an angle of
30 degrees. Bright sunlight or room light conditions can interfere with the remote control. If the
remote operation is unsatisfactory or stops working entirely, rst try replacing the remote
batteries, then try reducing the room lighting conditions.
LITHIUM BATTERY INSTALLATION OF REMOTE CONTROL
The remote control includes one CR2025(3V) lithium battery.
To replace the battery, gently push the clasp to the right direction accordingly to the
instruction and then pull out the battery compartment. Take the drained battery out and install
a new lithium battery (CR-2025) in the compartment with the positive polarity unwarded. then
push the compartment back to its position with a “click” sound indicating installation.
BASIC FUNCTION
SWITCHING ON THE UNIT
After connecting the power, press the /FUNC. button to turn on the unit, then press
the /FUNC. button again to choose FM / TAPE / CD / USB / BT or DAB mode.
NOTE: In CD / USB / AUX mode, when the unit is not providing the main function for 15 minu-
tes, the unit will automatically switch into standby mode. In the tape mode, only the tape stops
for 15 minutes, the unit will automatically switch into standby mode. To turn on the unit again,
press /FUNC. button or replug the unit.
ESD hints – The product maybe reset or not reset to operation of control due to electrostatic discharge,
just switch off and reconnect again.
TO ADJUST VOLUME
Press VOL.+/- button to increase or decrease volume.
HEADPHONE JACK
For private listening, connect a 3,5 mm headphone (not included) to the HEADPHONE jack.
The SPEAKER will be automatically disabled.
CAUTION: LISTENING AT A HIGH VOLUME OVER A LONG PERIOD IS NOT GOOD FOR YOUR EARS.
FM OPERATION
TUNING IN RADIO STATIONS
1. Press the /FUNC. button to choose radio mode: FM mode.
2. Tune to the desired station by pressing /TUN+ or /TUN- button, the station
frequency will show on the display.
3. Press the VOL.+/- button to adjust the volume to a comfortable level.
4. To optimize reception when listening to stations on the FM band, extend the telescopic
antenna to its full length. When the stereo signal is received, the “ST“ show on the display.
RADIO AUTO SCAN (SEARCH)
Press and hold the /SELECT/SCAN/PAIR button on unit, the unit will conduct auto scan and
program until having found a strong signal. The unit will start to broadcast from the P01 after
searching nished, then press the 10/FOLD./MEM+ or 10/FOLD./MEM- to choose the desired
stored station.
To Next Page
Loading...
Need help?
General
