JVC SP-UXH35 User Manual

13
English
To preset stations manually—Manual presetting
You need to preset stations separately for the FM and
AM bands.
• There is a time limit in doing the following steps. If
the setting is canceled before you finish, start over
from step 2 .
On the remote control ONLY:
1 Tune in to the station you want to
preset.
• See “Tuning in to a Station” on page 12.
2 Press SET.
3 Press UP or DOWN
to select a preset number.
4 Press SET again.
The tuned station in step 1 is stored in the preset
number selected in step
3 .
• Storing a new station on a used number erases
the previously stored one.
When you unplug the power cord or if a power
failure occurs
The tuner preset stations will be erased in a few days. If this
happens, preset the stations again.
Tuning in to a Preset Station
On the remote control ONLY:
1 Press TUNER to select the
band.
The unit automatically turns on
and tunes in to the previously
received station—either FM or AM.
• Each time you press the button, the band
alternates between FM and AM.
2 Press UP or DOWN
to select a preset number.
UP
DOWN
1
4
7
10
2
5
8
3
6
9
10
TUNER
UP
DOWN
To tune in to a preset station directly using the
number buttons
On the remote control ONLY:
Pressing the number button(s)
allows you to select the preset
number you want.
Ex.: For preset number 5, press 5.
For preset number 15, press
+10, then 5.
For preset number 20, press
+10, then 10.
For preset number 30, press
+10, +10, then 10.
SET
EN01-13_UX-H30[U]f.pm6 03.4.7, 11:47 AM13

JVC SP-UXH35 Specifications

General

Brand	JVC
Model	SP-UXH35
Category	Speaker System
Language	English