JVC UX-A3 User Manual

CLOCK ADJUSTMENT
Setting the current time
(when the UX-A3 is used for the first time)
(Example: to set the clock to 13:15.)
q) @) DISPLAY/CLOCK
a
taePirt IH
Cc» eS
ae ae, 3
oO
Connect the AC power cord; "0:00" will blink in the
display.
e Set to the standby mode; do not press the POWER
button.
Press the DISPLAY/CLOCK button for 2 sec. or more:
the hour's digits will blink.
Set to 13:00 by pressing the TIMER buttons
(UP/DOWN).
Press the ENTER button; the minute's digits will blink.
Set to 13:15 by pressing the TIMER buttons
(UP/DOWN).
Press the ENTER button; the time will light continuously
in the display.
© ©6060 © ©
© To set to the nearest second...
Press the ENTER button when you hear the time signal
from a TV or radio.
TIMER OPERATIONS
Timer recording
e The current time must be set correctly before you set
timer recording.
e Make sure that the erase protection tabs of the
cassette have not been broken off.
Operations
1. Set the POWER button to ON.
2. Load a cassette.
e Insert the cassette with the side to be recorded
facing out.
e Set the DIRECTION switch to the forward direction.
(The > indicator lights.)
e Set the reverse mode button to" => "or" 2 “and
set the DOLBY NR button as required.
3. Set the timer start and stop times, then set the required
volume, in this order. (Refer te "Setting the timer" on
page 47.)
e Set the timer about a minute before the broadcast to
be recorded is scheduled to start.
4. Press the TUNER/BAND buiton.
e Tune to the station to be recorded. (Refer to page
33.)
5. Set the POWER button to STANDBY.
DOWN UP
® CO/TUNING/TIMER
<P
|
o> pai’
(aed
4 NX
UX-A3 B/E/G/GI/EN
@Q) CD/TUNING/TIMER
ea >>]
SS
a
aa
_!
NL 7
=N
DOWN _ UP
Notes:
e Before performing timer recording or playback, it is
necessary to set the current time.
@ tis recommended to set the current time with the power
switch set to STANDBY so that the current display mode
is maintained.
e@ When the power cord is plugged in again after being
disconnected or power is restored after a power failure,
clock display will blink or light in the display. Set the
current time again.
e Press the DISPLAY/CLOCK to display the current time
during CD play, tape play or radio reception. The current
time will be displayed for 10 sec. after which the display
returns to the previous mode.
6. Press the O REC and PLAY buttons of deck
simultaneously
e If the DIRECTION switch is pressed before the (O)
REC and PLAY buttons are pressed, the (O) REC
and PLAY buttons cannot be pressed.
Note:
Timer recording will start at the preset time, the power will
not be switched off at the timer-off time during tape
operation, but it will be switched off when the tape ends.
However, the power cannot be switched off when the
reverse mode is set to" c&>" or the deck is set to the pause
mode.
e@ When timer recording is completed, the timer mode is
switched to the "TUNER" (timer reception of
broadcast) mode.
e To cancel timer operation
Press the TIMER button so that the timer mode indicator
(@ ) goes out.
If you do this, timer recording will not start at the timer start
time.
~J
~,
~~!
In
(No. 1850) 19

JVC UX-A3 Specifications

General

Brand	JVC
Model	UX-A3
Category	Stereo System
Language	English