JVC UX-A3 User Manual

UX-A3 B/E/G/GI/EN
Timer playback
e@ Timer playback of tapes, broadcasts and CDs is
possible.
Operations
@ Set the POWER switch to ON.
@ Set the timer start and stop times, then set the volume,
in this order. (Refer to "Setting the timer" on page 47.)
© Select the source sound.
Source sound Timer mode Operations
CD play cD Load a disc and press |
the m STOP/CLEAR
button to set the CD
mode.
Tape playback TAPE
Load a cassette tape
and select the tape
travel direction.
Radio broadcast TUNER Press the
TUNER/BAND button
to set to the tuner
mode and tune to the
required frequency.
e Timer playback of a CD is possible in programmed
order. (See page 27.)
e@ The volume can be set to 5 different levels.
@ Tune to the required frequency when the timer
playback of a broadcast is to be performed.
JOA9| SWN|OA >
ey
When the volume is set to level 1.
e@ When the power is switched on, it is possible to fade in
the sound from volume level 0 (zero) to the preset
volume.
@ To cancel timer operation
Press the TIMER button so that the timer mode indicator
( @) ) disappears. (To set to the timer mode again, press
the TIMER button twice so that the timer mode indicator
(@) appears.)
Notes:
e@ When the volume setting is set to "VoL -" (volume level
is not specified), the timer playback volume is set to
that of before setting the timer.
® To stop during timer playback, press the POWER button
to switch the unit off.
@ In the fade-in mode, the volume gradually increases
from zero.
22 (No. 1850)
When the volume is set to level 3.
When the volume is set to level 2.
@ Switch the power off.
(When performing the timer playback of tape, press the
PLAY button of the deck. Do not press the DIRECTION
switch before pressing the PLAY button.)
e Timer playback will start at the timer start time and the
power will be switched off at the timer stop time. (Tuner
or CD)
The power will not be switched off at the specified time
during tape operation and will switched off at the tape
end. However, the power will not be switched off when
the reverse mode is setto" "or the deck is set to the
pause mode.
The unit remains in the same timer mode even after the
power is switched off and the same timer function will be
repeated at the same time on the following day.
@ Volume setting and fade-in operation
When the volume is set to level 5.
When the volume is set to level 4.
Timer operation time =,

JVC UX-A3 Specifications

General

Brand	JVC
Model	UX-A3
Category	Stereo System
Language	English