JVC UX-C25BT Manual

13
Use of the FM radio
Press the
FM
button on the remote control or the
4. 5 mm
27 .0 m m
5. 8 mm
4. 3 mm
button on the main device until “FM”
appears on the display.
Setting a FM station
• Press the
TUN+
button on the remote control to increase the reception frequency.
• Press the
TUN-
button on the remote control to lower the reception frequency.
• If you hold down the
TUN+
or
TUN-
buttons, an automatic station scan starts which stops at the
rststationwhichisfound.
• Press the
Auto
button to start a station scan with automatic storage of the stations which are found.
A maximum of 30 stations will be stored in the order they were found.
• Press the
or buttons on the remote control or on the main device to scroll through the
memory list. Memory spaces which are unassigned will be indicated with “EMPTY“.
Use of Radio Data System (RDS)
RDSisatransmissionsystemwherebyFMstationtransmitotherusefulinformationalongwiththe
actual transmitter signal. This can be extracted from the normal transmitter signal and used for a range
of additional functions.
IfanRDSsignalisreceived,then”RDS” appears in the display below the frequency display and
after a while the station name and other information is displayed instead of the frequency.
RDS functions
The following information can be retrieved by repeatedly pressing the
RDS
button:
•Radiotext–Ifthestationisnotbroadcastinganyradiotext,then“NO TEXT” appears.
• PTY (Program Type) – If the station is not broadcasting any PTY signal, then “NONE” appears.
• Frequency and memory space of the station received
• Stereo / Mono display
• Time – If the station is not broadcasting any time signal, then “00_00_00” appears.
• Date – If the station is not broadcasting any date signal, then “00-00-00” appears.
Ifthereisinsufcientreceptionsignal,signalreceptioncanbedisturbedorimpossibledespite
showing “RDS” display.
Saving stations in station memory
Thereare40memoryspacesavailabletomakeiteasiertondFMstations.
To assign the memory, proceed as follows:
• Select a station to be saved
• Press the
PRG
buttonuntilastationmemoryspaceashesinthedisplay.Anemptymemoryspace
is indicated by “EMPTY”, an assigned space is shown with its frequency. You can also re-assign a
memory space which is already in use.
• Press the or buttons to select a memory space.
•Conrm or save using the
PRG
button. The preset memory number will no longer be
ashing.
• The stations can now be selected with the
or buttons.

JVC UX-C25BT Specifications

General

Brand	JVC
Model	UX-C25BT
Category	Stereo System
Language	English