16
Changing the Display Brightness
—DIMMER
You can dim the display window.
Setting the Clock
Without setting the built-in clock, you cannot use the Daily
Timer (see page 20).
• To exit from the clock setting, press CLOCK/TIMER as
required.
• To go back to the previous step, press CANCEL.
1 Activate the clock setting mode.
• If you have already adjusted the clock before, press the
button repeatedly until the clock setting mode (see
page 20) is selected.
2 Adjust the hour.
3 Adjust the minute.
“CLOCK OK” appears and the built-in clock starts
working.
To check the current time during play
If there is a power failure
The clock loses the setting and is reset to “0:00.” You need
to set the clock again.
Turning Off the Power
Automatically
To turn off the System after playback is over—
Auto Standby
This function works only when the source is CD.
When Auto Standby is in use, the A.STBY indicator lights
on the display.
When the disc playback stops, the A.STBY indicator starts
flashing.
If no disc operation is done for about 3 minutes while the
indicator is flashing, the System turns off (stands by)
automatically.
To turn off the System after a certain period of
time—Sleep Timer
1
Specify the time (in minutes).
2 Wait until the set time goes off.
To check the time remaining until the shut-off time
• If you press the button repeatedly, you can change the shut-
off time.
Remote
ONLY
DIMMER
DIM ON
DIM OFF
(Canceled)
Remote
ONLY
CLOCK
/TIMER
PRESET UP
PRESET DOWN
SET/RESUME
PRESET UP
PRESET DOWN
SET/RESUME
DISPLAY
Clock
Source information
Remote
ONLY
A.STANDBY
(No indication)
A.STBY
Canceled
SLEEP
10 20 30 60 90 120
OFF
(Canceled)
SLEEP
UX-G50[UJ].BOOK Page 16 Monday, June 5, 2006 5:59 PM
To Next Page
Loading...
Need help?
General
