17
Changing the Color System and Scanning
Mode
INFO
Remote
ONLY
You can select the video output to match it to the color
system of your TV (NTSC or PAL).
• If you connect a progressive TV through the VIDEO
OUT (COMPONENT) jacks, you can enjoy a high
quality picture by selecting progressive scanning mode.
Before playback...
PAL/NTSC
Select for a conventional PAL or NTSC TV.
PAL PRG/
NTSC PRG
Select for a PAL or NTSC progressive TV.
• The PRGR (Progressive) indicator lights
on the display.
Changing the Picture Tone
Remote
ONLY
While showing a playback picture on the TV, you can
select a preset picture tone, or adjust it and store your own
preference.
To select a preset picture tone
1 While playing, display VFP setting screen.
(while holding...)
Remote
ONLY
2 Select a preset picture tone.
NORMAL
Normally select this.
CINEMA
Suitable for a movie source.
USER1/USER2
You can adjust parameters and
can store the settings. (See the
following.)
To clear the screen, press VFP again while holding SHIFT.
To adjust the picture tone
1 Select “USER1” or “USER2.”
• Follow steps 1 and 2 explained in “To select a preset
picture tone.”
2 Select a parameter you want to adjust.
GAMMA
Adjust if the neutral color is bright or
dark (–3 to +3).
BRIGHTNESS
Adjust if the entire picture is bright
or dark (–8 to +8).
CONTRAST
Adjust if the brightness ratio is
unnatural (–7 to +7).
SATURATION
Adjust if the picture is whitish or
blackish (–7 to +7).
TINT
Adjust if the human skin color is
unnatural (–7 to +7).
SHARPNESS
Adjust if the picture is indistinct
(–8 to +8).
3 Adjust the parameter.
4 Repeat steps 2 and 3 to adjust other parameters.
To clear the screen, press VFP again while holding SHIFT.
(while holding...)
On the TV
EN09-18_UX-GP7V[U]1.indd 17EN09-18_UX-GP7V[U]1.indd 17 6/16/08 11:23:42 AM6/16/08 11:23:42 AM
To Next Page
Loading...
Need help?
General
