1-14 (No.MB230)
3.1.12 Removing the power transformer (See Fig.22)
• Prior to performing the following procedures, remove the side
panels L/R, top cover assembly, rear cover, tuner, video output
board, main board, power supply board and power amplifier
board.
(1) From the top side of the main body, cut off the tie bands
holding the wire to the support board.
Reference:
After reassembling, hold the wire with the new tie bands
as before.
(2) Remove the four screws S attaching the power transformer.
Fig.22
S
S
Wire
Tie band
Support board
Tie band
Power transformer
To Next Page
Loading...
Need help?
General
