21
Basic operations
English
Basic operations
In the following description, the buttons on the remote control unit are mainly used, however, you may use the
corresponding buttons on the front panel of the unit if available.
Turning on/off the unit
Press DVD STANDBY/ON on the remote control unit or press STANDBY/ON on the front panel.
• You can turn on the unit by pressing the
3
button. In this
case, the unit starts playback if the disc is set in the disc
tray.
• If no disc is set, “NO DISC” appears on the display window.
• You can turn on the unit by pressing the 0 (OPEN/CLOSE)
button on the front panel. In this case, the disc tray opens.
Inserting and removing discs
1
Press0 (OPEN/CLOSE) to open the disc tray.
2
Place the disc in the tray.
3
Press 0 (OPEN/CLOSE) to close the disc tray.
The unit reads the disc information and the corresponding opening display (depending on the disc type) appears
on the TV screen (See page 9).
OPEN
/CLOSE
TV DVD
REPEAT
123
56
89
7
4
3D
PHONIC
TV/VIDEO
CANCEL
TV1 TV2 TV3
TV4 TV5 TV6
TV7 TV8 TV9
TV
-/-- TV0
MUTING
RETURN
TV DVD
STANDBY/ON
DVD STANDBY/ON
STANDBY
STANDBY/ON
PAUSEPLAYSTOP
SKIP
OPEN/CLOSE
387
0
¢4
PROGRESSIVE
DVD/VIDEO CD/CD
DVD/CD PLAYER
STANDBY/ON
NOTE
• Even if you press the DVD STANDBY/ON or STANDBY/ON button to turn off the unit, the unit is not disconnected from
the AC power source as long as it is connected to the wall outlet. This state is called the standby mode. In this state, the unit
consumes a very small amount of power.
NOTES
• Do not load a non-playable disc. For details about playable and non-playable disc types, see page 13.
• When loading a disc in the tray, be sure to position the disc inside the recess. Otherwise, the disc may be damaged when the
tray is closed, or the disc may not be removed from the unit.
• Do not use any stabilizer when playing back a disc.
• With some DVD VIDEO discs, the unit starts playback automatically after inserting the disc.
• If you insert a DVD VIDEO disc whose region code does not match the unit, “REGION CODE ERROR!” is shown in the DVD
opening display. For detail about the region code, see page 13.
STANDBY
STA
NDB
Y
ON
P
AUS
E
P
LAY
ST
OP
SKIP
O
PEN/CLO
SE
3
8
7
0
¢4
XV-S
30
DVD/CD
PL
AYER
VCDVD
GR
O
UP
TITL
E
T
RAC
K
CH
AP
D
.M
IX
A
-
B
1
A
NG
L
E
LPCM
MPEG
DOLBY
DIGIT
AL
PRO
GRA
M
RA
NDOM
DTS
PRO
GRESSIVE
D
VD
S
U
PE
R
V
CD
V
CD
C
D
With the label side up
To insert an 8-cm disc, place
it in the inner recess.
•
To Next Page
Loading...
Need help?
General
