Kärcher B 40 User Manual

- 7
The removal will take place in the opposite
order of the installation.
몇 CAUTION
When the cleaning head is removed, the
stability of the appliance can be compro-
mised; ensure a safe stance.
Possibly support the rear to prevent tipping.
Please observe the following warning notes
when handling batteries:
 DANGER
Risk of explosion. Do not place tools or the
like on the battery, i.e. on the terminal poles
and cell connectors.
Risk of injury. Ensure that wounds never
come into contact with lead. Always clean
your hands after having worked with batter-
ies.
* Appliance requires 2 batteries
1)
Complete set (24 V/105 Ah) incl. connect-
ing cable, order no. 4.035-449.0
2)
Complete set (24 V/76 Ah) incl. connect-
ing cable, order no. 4.035-447.0
3)
Complete set (24 V/80 Ah) incl. connect-
ing cable, order no. 4.035-990.0
 Push the appliance forward about 2 m
so that the steering rollers point toward
the rear.
 Lower the cleaning head.
 Empty the fresh and waste water tank.
 Loosen the tank lock and tilt the tank
upwards.
 Place the batteries in the tub so that
they are flush with the cleaning head,
insert the accompanying retaining
blocks or foam material parts to safe-
guard them.
몇 CAUTION
When the batteries are installed and re-
moved, the stability of the appliance can be
compromised; ensure a safe stance.
 Connect the connection cable to the
free battery poles (+) and (-).
 Connect pole using the enclosed con-
necting cable.
ATTENTION
Pay attention to correct poles.
Installation sketch for 2 batteries
 Swivel the water reservoir all the way
down, check the lock.
Note:
Charge the batteries before commissioning
the appliance.
See also "Charging the batteries".
ATTENTION
Risk of damage due to tipping appliance;
remove batteries only if the appliance is
equipped with a cleaning head.
 Set the programme selector switch to
"OFF".
 Push the appliance forward about 2 m
so that the steering rollers point toward
the rear.
 Lower the cleaning head.
 Loosen the tank lock and tilt the tank
upwards.
 Clamp off the minus pole of the battery.
 Clamp off the remaining cables from the
battery.
 Remove the support blocks or the foam
pieces.
몇 CAUTION
When the batteries are installed and re-
moved, the stability of the appliance can be
compromised; ensure a safe stance.
 Remove the batteries.
 Dispose of the used batteries according
to the local provisions.
To ensure a reliable operation of the appli-
ance maintenance contracts can be con-
cluded with the competent Kärcher sales
office.
In case of danger of frost:
 Empty the fresh and waste water tank.
 Store the appliance in a frost-protected
room.
 DANGER
Risk of injury! Set the programme selector
switch to "OFF" and pull the mains plug of
the charger prior to performing any work on
the appliance.
 Drain and dispose of the dirt water and
the residual fresh water.
Dismantling the cleaning head
Batteries
Observe the directions on the bat-
tery, in the instructions for use and
in the vehicle operating instructions
Wear eye protection
Keep children away from acid and
batteries
Danger of explosion
Fire, sparks, naked flames and
smoking must be strictly avoided
Danger of chemical burns
First aid
Warning note
Disposal
Do not throw the battery into the
regular waste
Recommended batteries
B 40 B 60
Order No. Description
X -- 6.654-093.0
2)
76 Ah - main-
tenance-free
12 V*
X -- 6.654-290.0
3)
80 Ah, - low
maintenance
12 V*
X X 6.654-141.0
1)
105 Ah -
maintenance-
free
12 V*
-- X 6.654-242.0 170 Ah -
maintenance-
free
6 V
-- X 6.654-124.0 180 Ah -
maintenance-
free
6 V
-- X 6.654-086.0 180 Ah, - low
maintenance
6 V
Insert batteries and connect
Removing the batteries
Maintenance contract
Frost protection
Faults
19EN

Kärcher B 40 Specifications

General

Brand	Kärcher
Model	B 40
Category	Floor Machine
Language	English