EasyManuals Logo
Home>Kärcher>Pressure Washer>K 2.300

Kärcher K 2.300 User Manual

Kärcher K 2.300
15 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
14 English
WARNING
Disconnect the unit from the power
source before making any repair.
TROUBLESHOOTING
Issue Cause Solution
Motor will not start On/Off switch is in the “OFF”
(0) position.
Turn switch to the “ON” (I) po-
sition
Power cord is not plugged in. Plug in power cord.
Electrical outlet does not sup-
ply adequate power.
Try a different outlet.
Tripped GFCI plug. Press “RESET” button on
GFCI plug.
Tripped circuit breaker. Switch off pressure washer.
The reset comes automatically
once the temperature of the
unit drops.
Unit does not
reach high pres-
sure.
Diameter of garden hose is too
small.
Replace with a 16 mm (5/8
inch) or larger garden hose.
Water supply is restricted. Check garden hose for kinks,
leaks and blockage.
Not enough inlet water supply. Open water source full force.
Water inlet filter is clogged. Remove filter and rinse out in
warm water.
Spray wand is on low pressure
position.
Turn spray wand to high pres-
sure position.
Output pressure
varies high and
low.
Not enough inlet water supply. Turn water on full force. Check
garden hose for kinks, leaks or
blockage.
Pump is sucking air. Check that hoses and fittings
are air tight. Turn off machine
and purge pump by squeezing
trigger gun until a steady flow
of water emerges through the
nozzle.
Water inlet filter is clogged. Remove filter and rinse out in
warm water.
Discharge nozzle is obstruct-
ed.
Blow out or remove debris with
a fine needle.
Calcified gun, hose or spray
wand.
Run distilled vinegar through
detergent suction tube.

Other manuals for Kärcher K 2.300

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kärcher K 2.300 and is the answer not in the manual?

Kärcher K 2.300 Specifications

General IconGeneral
Maximum flow rate360 l/h
Working pressure (max)110 bar
Maximum input water temperature40 °C
Form factorUpright
Hose length4 m
Water filterYes
Product colorYellow
Surface cleanerNo
Power consumption (typical)1400 W
Weight and Dimensions IconWeight and Dimensions
Depth242 mm
Width280 mm
Height783 mm
Weight4800 g

Related product manuals