English 17
Turn off the appliance.
Empty the full reservoir (refer to chapter
"Empty reservoir").
Rinse the reservoir thoroughly with
clear water.
Remove the accessories from the appli-
ance after each use and disassemble
the hose, nozzle and extension pipes.
Note: Possibly remaining water can
drip out, therefore you should place
these into the shower or bathtub.
Flush the accessories separately under
running water and let air dry.
Clean the foam filter under running wa-
ter; let it dry before reinserting it.
Leave the appliance open to let it dry.
Storing the appliance. Store the ac-
cessories on the appliance and store in
dry rooms.
Risk of injury
Always switch off the appliance and pull out
the mains plug before care and mainte-
nance work.
With an uneven spray jet.
Illustration
Loosen nozzle attachment and pull out,
clean or replace spray nozzle.
1 x year or as needed.
Illustration
Turn the lock and loosen it. Take out
the sieve and rinse it with water.
Fill up fresh water reservoir.
Check the fresh water reservoir for cor-
rect fit.
Detergent pump defective, contact Cus-
tomer Service.
Clean the spray nozzle of the spray ex
floor nozzle.
Close the surrounding air separator at
the handle.
See diagram 11
Accessories, suction hose or suction
tubes are clogged, please remove the
obstruction.
Filter bag is full, insert a new filter bag
(for the order no. please see the spare
parts list at the end of the present in-
structions).
Cleaning the foam filter
Fill up fresh water reservoir.
Plug in the main plug.
The overheat alarm has been triggered,
please allow appliance to cool down.
Shutting down
Maintenance and Care
Cleaning the device
Clean the sieve in the fresh water
reservoir
Faults
No water exiting from nozzle
Spray stream uneven
Insufficient vacuum performance
Detergent pump noisy
Appliance is not running