Keithley 2200 Series User Manual

Performance Verification
Table 27: Test equipment (cont.)
Item Minimum requirements Example
9. 50 mΩ resistor for Remote
Sense testing
(2 required)
Oneofthese50mΩ resistors
may be substituted with
item 7.
0.050 Ω,5W.
To perform the tests as illustrated, both leads of each
resistor require a Banana Jack connector (e.g. Pomona
model 4834).
OHMITE 15FR050E
10. Load resistor for Voltage
Noise testing
Loading resistors for high current in voltage mode, and
high voltage in current mode
All resistors should be rated for at least 50 W. O hms
tolerance within 5%. Resistor composition is not critical.
To perform the tests as illustrated, both leads of the load
resistor require a Banana plug/jack (or equivalent) to
connect to the power supply.
Channel 1 12 Ω Vishay/Dale RH05012R00FE02
Channel 2 12 Ω Vishay/Dale RH05012R00FE02
Channel 3 (2230-30-1 and
2230J-30-1 only)
2.5 Ω Vishay/Dale RH0502R500FE02
11. Load Resistor for Current
Noise testing
1 Ω, 100 W, 5%
To perform the tests as illustrated, both leads of the load
resistor require a Banana plug/jack (or equivalent) to
connect to the power supply.
Vishay/Dale HL10006Z1R000JJ
12. Oscilloscope 20 MHz bandwidth limited oscilloscope at 1 mV/division Tektronix DPO3012
13. Oscilloscope probe Low capacitance 1 MΩ/10 MΩ 1X/10X 6 MHz/200 MHz
probe
Tektronix P2220, 1X probe
14. Oscilloscope probe Low capacitance 10 MΩ 500 MHz probe
Tektronix P6139A, 10X probe
15. Coaxial cable 50 Ω BNC, male-to-male
Tektronix part number:
012-0482-00
16. BNC adapter BNC female to banana breakout
Pomona Electronics 3073
Series 2200 Multichannel Programmable DC Power Supplies Technical Reference 25

Keithley 2200 Series Specifications

General

Brand	Keithley
Model	2200 Series
Category	Power Supply
Language	English