Performance Ve rification
Table 27: Test e
quipment
Item Minimum requi
rements
Example
1. Connectors Connectors fo
r hook up wire assemblies and test
resistors, item numbers 5, 6, 9, 10, and 11.
(Qty. 6) #10 fork lugs similar to Tyco part number
52951
(Qty, 14) Stackable, gold plated, banana plugs/jacks
similar to P
omona model 4897-0. Used for lower
current connections, and connection to the load
resistors (items 1 0 and 11) used for noise testing.
(Qty. 4) Sheathed Banana Jacks similar to Pomona
model 4834
to put connectors on the R esistors
(item 9).
2. AC power source Variable AC output from 90 to 265 VAC w ith at least
750 VA capacity
Kikusui P CR2000M
3. Electronic load
Variable DC Load capable of 6 ADC and 40 VDC B&K Precision 8510
4. DC voltmeter
Voltage measurement at 12 mV through 40 V to better
than 100 ppm accuracy with the ability to multiply the
result b
y a scalar.
Keithley 2000 DMM
5. High current hook up wire
(High c
urrent connections are
indicated with bold lines in the
setup illustrations)
18 AWG (
minimum) hookup wire assemblies.
To perform all tests, the following wire assemblies need
to be created:
#10 fork lug to #10 fork lug, Qty 2, (included in
Guild
line 92301 if used)
Stack
able B anana to #10 fork lug, Qty 2
Stack
able Banana to Bare Wire Qty 2.
Wire lengths are not critical.
6. Low c
urrent hook up wire
(Low current connections are
indicated with light lines in the
setu
p illustrations)
22 AWG (minimum) hookup wires
To perform all tests, the following wire assemblies need
to be
created:
Ban
ana plug to Banana plug, Qty 2
Bar
e Wire to stackable Banana, Q ty 2
Bar
e Wire to Banana, Qty 2
Wire lengths are not critical.
7. 50 mΩ precision shunt resistor 0.050 Ω ±100 ppm at 25 W ±4 ppm/°C temperature
coefficient
Guildline 9230A-50
8. Current sense resistor cabling Kelvin 4 terminal measuring cables for shunt resistor to
v
oltmeter
Guildline 92301 cable set
24 Series 2200 Multichannel Programmable DC Power Supplies Technical Reference
To Next Page
Loading...
Need help?
General
