-,ING bi :_ BOBBIN THREAD
1. Raise presser foot lever. Hold needle
thread loosely in left hand and rotate
handwheel toward you one complete
turn.
2. Bring bobbin thread up by pulling
upper thread.
3. Pull both threads under and to the
back of the presser foot, leaving 3 to
4 inches of thread clear.
If you cannot pick up bottom thread by
following steps given above, then check:
1. Is needle threaded from front to back?
2. Is thread tangled around needle?
3. Is there 3 to 4 inches of thread coming
from the bobbin case?
4. Is thread from bobbin case tangled?
15
To Next Page
Loading...
Need help?
General
