WINDING THE BOBBIN
1. Release clutch by turning clutch knob
toward you.
2. Draw thread from spool through
bobbin winder tension disc as shown.
3. Pull end of thread through hole in
bobbin as shown.
4. Place bobbin onto bobbin winder
shaft with end of thread coming from
the top of the bobbin. Push bobbin
winder shaft to the right until it clicks.
Holding onto end of thread, start
machine. When bobbin is slightly
filled, snip off end of thread.
5, Wind thread until winder stops.
Remove bobbitl. Clip thread.
6. Tighten clutch knob.
12
To Next Page
Loading...
Need help?
General
