THREADING TOP THREAD
' I "_'f
Place spool on spool pin as shown, with
thread coming from the back of the
spool.
Draw thread through top thread guides.
Holding spool stationary with right hand,
pull the end of the thread between the
tension discs as shown above (_.
Pull the end of the thread taut with left
hand. This will pull the spring wire up
and past the end of the hook. The thread
will then slip into the hook when the
spring is released as in (_ .
Release spool of thread and thread
machine through take-up lever (_ and
thread guide (6) as shown above. Thread
then passes through guides (_ and (_.
Thread needle _ from front to rear.
14
To Next Page
Loading...
Need help?
General
