FASTENING A SEAM
Be sure both threads are drawn back
under the presser foot. Lower needle
into fabric about 1/2 inch from begin-
ning of seam. Turn thereverse stitch
control clockwise and stitch in reverse
until needle reaches beginning of seam.
Release control and complete seam.
When you reach the end, turn the con-
trol clockwise and sew back over 1/2
inch of completed seam.
i ; }i
TURNING A SQUARE CORNER
To turn a square corner 5/8" from the
fabric edge, stop stitching with the needle
tip piercing the fabric, when reaching the
cornering guide as shown. Raise the
presser fopt, turn fabric. New stitching
line will align with 5/8" seam guide on
side of needle plate. Lower the presser
foot and begin stitching in new direction.
19
To Next Page
Loading...
Need help?
General
