ENGLISH
13
B
AKE
SLOW
COOK
B
ROIL
WARM
&
H
OLD
O
VEN
LOCKOUT
S
TOP
CLEAR
ON/OFF
O
VEN
L
IGHT
CLOCK
O
VEN
C
OOK
T
IME
S
ELECT
C
LEAN
O
N/OFF
K
ITCHEN
T
IMER
D
ELAY
S
TART
A
DD 1
M
INUTE
R
ECIPE
R
ECALL
O
VEN
P
REHEAT
D
OOR
L
OC KED
Control Pad Features
READ THE INSTRUCTIONS CAREFULLY BEFORE USING THE OVEN. For satisfactory use of your oven, become
familiar with the various features and functions of the oven as described below. Detailed instructions for each feature
and function follow later in this Use & Care Guide.
Slow Cook—
Used to set the Slow
Cook feature.
Note: The oven function will not work if the time of day clock is not set.
Bake Pad- Used to
enter the normal baking
mode temperature.
Broil Pad- Used to
select the variable broil
function.
Select Clean Pad-
Used to select the
self-cleaning cycle.
Stop Pad- Used to clear
any function previously
entered except the time of
day and minute timer.
Push Clear pad to stop
cooking. Also used to
activate the Oven Lock
feature.
Up and Down arrow pads- Used
along with the function pads to
select oven temperature, cooking
time, start time (when programming
an automatic start time), time of
day, clean time and minute timer.
Clock Pad-
Used to set the
time of day.
Feature indicator
lights- These light
show which feature is
in use.
Cook Time Pad-
Used to enter the
length of the baking
time.
Delay Start Pad- Used
to set the desired start
time for baking. Can be
used with OVEN COOK
TIME to program a
delayed bake cycle.
Kitchen Timer
Pad- Used to set
or cancel the
minute timer. The
minute timer does
not start or stop
cooking.
Oven, Preheat, Door Locked & Cooktop Locked
lights- The "oven" light indicates that the oven is
functioning. The "Preheat" light will glow when the
oven is first set to operate, or if the desired
temperature is reset higher than the actual oven
temperature. The "Door Locked" light will flash until
the door locks when the self-clean cycle is in use. It
glows constantly after the door locks.
Oven Interior Light Pad-
Used to turn oven interior
light ON and OFF.
Warm & Hold Pad-
Used to set the Keep
Warm feature.
Add 1 Minute Pad- Used to add 1
minute to the Timer Countdown. This
feature works with the Kitchen Timer
only and does not affect any cook time
or start time functions.
For a silent control panel
When choosing a function, a beep will be heard each time a pad is pushed. If desired, the controls can be programmed for
silent operation.
To tell if your oven is set for normal or silent operation push and hold
for 7 seconds. "- -" or "SP" (speaker) appears in
the display. Within 5 seconds, press or to switch between normal sound operation and silent operation mode. The
display will show either "- -" or "SP". Wait 5 seconds to return to normal operating mode. Note: If "SP" appears, the control will
operate with normal sounds and beeps. If "- -" appears, the control is in the silent operation mode.
Temperature Conversion (Fahrenheit / Celsius)
The electronic oven control is set to operate in °F (Fahrenheit) when shipped from the factory. The oven can be
programmed for any temperature from 170°F to 550°F (77°C to 288°C).
To change the temperature to °C (Celsius) or from °C to °F (control should not be in a Bake or Clean mode):
1. Press and hold
for 7 seconds until °F or °C appears in the display.
2. Press or to change °F to °C or °C to °F.
3. Wait 5 seconds or press
to accept the changes.
To Operate the Oven Light
The interior oven light will automatically turn ON when the oven door is opened. Press
to turn the interior light ON
and OFF whenever the door is closed. The interior oven light is located at the upper left rear wall of the oven interior and is
covered with a glass shield held by a wire holder. The glass shield must be in place whenever the oven is in use. To
change the interior oven light, see changing the Oven Light in the General Care & Cleaning section in this Use and Care
Guide.
Recipe Recall—
Used to set the
Recipe Recall
feature.
To Next Page
Loading...
Need help?
General
