Kenmore 911.40161 User Manual

OPERATION
Oven Control, Clock and Timer
Your new conl;rolhas a series of tones
that will sound at different times. These
tones may sound while you set the
control for an oven function, or at the
end of the oven function. It will also alert
there may be a problem with the
.lions, Below are the types of tones
and a brief description of each.
TONES WHILE SETTING THE
CONTROL--When you press a touch
pad you wilt hear a beep. This beep will
let you know you have placed enough
pressure on the pad to activate it, (The
arrow pads do not beep.)
END OF TIMED CYCLE TONE_t
the end of a timed cooking function,
you willhear 3 short beeps followed by
I beep every 6 seconds. This 6 second
beep will continue to sound until the
CLEAR/OFF pad is pressed or you
may select the special feature to cancel
this 6 second beep from sounding at
the end of future cycles.
TO CANCEL THE 6 SECOND
BEEP
1. Press and hold the BAKE and
BROIL pads, at the same time
for 3 seconds, until the display
shows "SF".
2. Press the KITCHEN TIMER pad.
The display willshow "CON
BEEP" (continous beep).
3. Press the KITCHEN TIMER pad
'_gein. The display will show
BEEP' (beep canceled).
4, Press the START pad to cancel the
6 second beep and leave the
special feature mode.
If you would like to return the 6 second
beep, repeat steps above until the
display shows your choice and press
Start.
ATTENTION TONE--This tone will
sound if you make an error or an
oversight is made while setting an
oven function.
Examples would be:
a. Setting function and not pressing
Start.
b. Pressing an additional function pad
without first setting a temperature or
time.
e, ERR will flash if you set an invalid
temperature. Press the CLEAR/OFF
pad to dear the control and reset
your oven function.
Any of these can be quickly identified
by watching the display.
PREHEAT TONE--When you set an
oven temperature, the oven
automatically starts to heat. When the
temperature inside the oven reaches
the temperature you have set, a tone
will sound to let you know the oven is
ready for baking.
If you set an oven function and the
control beeps while the display is
flashing "F" and a number or letter
such as "F.4" or "Fr' there may be a
problem with the control or oven.
Simply press the CLEAR/OFF pad and
wait about an hour. Try setting the
function again. If the code repeats, write
down the flashing code and ca!l for
service. Te!l the technician what code
was flashing.
9

Kenmore 911.40161 Specifications

General

Brand	Kenmore
Model	911.40161
Category	Oven
Language	English