- 7 -
ASSEMBLY INSTRUCTIONS
7. Insert the locking end of the hose into
the vacuum port of the collection tank
and turn clockwise to lock into place.
8. Choose the desired accessory and insert
onto the end of hose or extension wand.
OPERATING INSTRUCTIONS
VACUUMING OPERATION
WARNING
Be sure to read, understand, and apply
information entitled ‘important safety
instructions’. Do not vacuum in areas
with flammable gases, vapors, or
explosive dusts in the air. Flammable
gases or vapors include but are not
limited to: lighter fluid, solvent type
cleaners, oil-based paints, gasoline,
alcohol, or aerosol sprays. Explosive
dusts include but are not limited to:
coal, magnesium, grain, or gun powder.
To reduce the risk of health hazards
from vapors or dust, do not vacuum
toxic materials.
WARNING
Do not plug the power cord into
electrical supply. Make sure the plug
is disconnected before changing the
filters.
NOTE:
To reduce the risk of electric shock,
this vacuum cleaner has a polarized plug;
one blade is wider than the other. This plug
will fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet,
reverse the plug. If it still does not fit,
contact a qualified electrician to install the
proper outlet. Do not change the plug in
any way.
CAUTION
Do not vacuum drywall dust, fireplace
soot, or ash with this vacuum. This is a
very fine dust which will not be captured
by the filter and may cause damage to
motor.
CAUTION
THIS VACUUM IS INTENDED FOR DRY
PICK-UP ONLY.
To Next Page
Loading...
Need help?
General
