1. Verify that the power cord is
disconnected from the outlet.
2. Disconnect the hose from the vacuum.
3. Undo the latches and remove the power
head from the collection tank. Place
power head on a soft, clean surface
upside down.
4. Clear all dirt or debris from the
collection tank and hose into a proper
waste container.
5. Clean or replace the filters.
6. Check the hose, attachments, and power
cord to verify that they have not been
damaged.
7. Place the power head back on collection
tank and secure latches.
IMPORTANT!
Clean or change the filter
regularly for best performance.
ALWAYS
USE THE CARTRIDGE FILTER FOR DRY
VACUUMING.
If the machine is used
without the cartridge filter, the motor will
burn out and the warranty will be voided.
Always keep spare filters on hand.
NOTE:
The filters included are made
of high-quality materials designed to stop
small dust particles. The cartridge filter
should be used for dry pick-up only. A
dry cartridge filter is necessary to pick
up dust. If the cartridge filter is wet, it will
clog quickly and be very difficult to clean.
Handle the filter carefully when removing
it for cleaning and replacing it. Check the
filters for tears or small holes. A small hole
can let dust pass through and out of the
filter. Do not use a filter with holes or tears;
replace it immediately.
- 17 -
VACUUM MAINTENANCE AND CARE
WARNING
Always disconnect the plug from the
outlet before removing the power head
from the collection tank.
EMPTYING THE COLLECTION TANK
To Next Page
Loading...
Need help?
General
