INSTALLINGYOURREFRIGERATOR
These instructions were provided to aid
you in the installation ol your
refrigerator
MEASURINGTHEOPENING
A one-half inch (72")of air space must be
provided for the back of the refrigerator.
When installing your refrigerator,
measure carefully.
Subflooring or floor coverings (i.e.
carpet, tile, wood floors, rugs)may make
your opening smaller than anticipated.
Some clearance may be gained by
using the leveling procedure under
How to Level Your Refrigerator.
IMPORTANT: If refrigerator is to be
installed into a recesswhere top of
refrigerator is completely covered, use
dimensions from floor to top of hinge
cap to verify proper clearance.
TRANSPORTINGYOUR
REFRIGERATOR
Follow these tips when moving the
refrigerator to final location:
> NEVER transport refrigerator on its
side. If an upright position is not
possible, lay refrigerator on its back.
Allow refrigerator to sit upright for
approximately 30 minutes prior to
plugging refrigerator in to assure oil
returns to the compressor. Plugging
refrigerator in immediately may cause
damage to internal parts.
> Use an appliance dolly when moving
refrigerator. ALWAYStruck
refrigerator from its side-NEVER
from its front or back.
> Protect outside finish of refrigerator
during transport by wrappingcabinet
in blankets or inserting padding
between the refrigerator and dolly.
*- Secure refrigerator to dolly firmly,with
straps or bungee cords Thread straps
through handles when possible. DO NOT
overtighten Overtightening restraints may
dent nr damage outside finish
SELECTINGTHEBEST
LOCATION
Observe these points when choosing the
final location for your refrigerator:
> DO NOT install refrigerator near
oven, radiator or other heat source. If
not possible, shield refrigerator with
cabinet material.
> DO NOT install where temperature
fans below 55° F (13° C). Malfunction
may occur atthis temperature.
> Toassure proper door closure, follow
the leveling instructions in the
section, How te Level Your
Refrigerator.
OPENINGANDCLOSING
YOURFRESHFOODDOORS
Your new refrigerator is uniquely
designed with two fresh food doors.
Eitherdoor can be opened or closed
independently of one another.
There is a vertically-hinged section on
the 1ellfresh food door called the
SmartSeal.When the left door is closed,
the hinged section automatically forms a
seal between the two doors when both
doors are closed.
When the left door is opened, the
SmartSeal automatically folds inward so
that it is out of the way.
pror to 80S_l_g:: , ,-::,
1
To Next Page
Loading...
Need help?
General
