HOWTOLEVELYOUR
REFRIGERATOR
If your refrigerator requires an ice maker
water supply connection, refer to How
to Connect the Water Supply section
before leveling your refrigerator.
MATERIALS NEEDED
_" _ hex head driver
:.- Level
1. Remove toe grille and bottom bracket
covers (see previous instructions).
2. Turn both front adjustment screws (A)
clockwise l.oraise and counter-
clockwise to lower.
3. Turn both rear adjustment screws (B)
clockwise to raise and
counterclockwise to lower.
4 Turn stabilizing legs (C) clockwise
until firmly against floor.
5. Turn front roller adjustment screws
(A) 2 to 3 times counterclockwise, so
that full weight of refrigerator rests on
stabilizing legs (C).
6. Using a level, make sure front of _
refrigerator is '/4"(6 mm) or V_bubble
higher than back ol refrigerator.See
leveling step 3 for assistance.
7_ Replace toe grille and bottom bracket
covers. See markings on inside of toe
grille to insure proper placement.
> Snap bottom portion into place
first. Press down on top part of
grille until top portion snaps into
place.
I'ti
6
To Next Page
Loading...
Need help?
General
