KENT EVOLUTION8 INSERT User Manual

LOCATION
Select a location for your wood heater with great
care.
* Do not place your heater in areas of high
traffic, near furniture or draperies.
* Check that the intended location will not
interfere with ceiling joists, rafters, valleys and
ridges.
CLEARANCES
It is vital that the heater be installed the proper
distance from combustible surfaces like wood,
gyprock and curtains.
The diagrams show both parallel and corner
installations.
Failure to maintain these minimum distances may
result in a fire for which your insurer may refuse to
cover.
REDUCED CLEARANCES
These clearances can be reduced with proper
heat shielding. Basically a noncombustible
surface is placed between the heater and the
combustible wall. It is vital that an unobstructed
air flow be maintained between the two surfaces
to remove excess heat.
HEARTH CLEARANCES
It is necessary to ensure that the heater is
positioned on the hearth so that the requirements
below are observed. The front of the hearth
should extend past the heater door by the distance
specified as D. The side of the hearth should
extend past the heater door by the distance
specified as E on each side.
INSTALLATION - FREESTANDING
HEATERS ONLY
GFEDCBAModel
All dimensions are in millimetres
Evolution 8
Evolution 6
Evolution 4
with Maxiheat Default Flue Kit
with decromesh
with flue pipe, no shield
with decromesh
with Maxiheat Decromesh Flue Kit
with Maxiheat Default Flue Kit
10331230200670125525250
10331230200670200525375
93099020040050400100
930990200400100400300
880940200430100300150
880940200430170300275
E
D
G min
F
min
Hearth Dimensions and
Clearances
C
Corner Installation
A
B
Parallel Installation
5

KENT EVOLUTION8 INSERT Specifications

General

Brand	KENT
Model	EVOLUTION8 INSERT
Category	Wood stove
Language	English