Kenwood KDC-136 User Manual

16
|
English
Installation
non-Japanese cars
Firewall or metal support
Screw (M4X8)
(commercially available)
Self-tapping screw
(commercially available)
Metal mounting strap
(commercially available)
Bend the tabs of the
mounting sleeve with a
screwdriver or similar utensil
and attach it in place.
⁄
• Make sure that the unit is installed securely in place. If the
unit is unstable, it may malfunction (for example, the sound
may skip).
Japanese cars
1
Refer to the section <Removing the hard rubber
frame> and then remove the hard rubber frame.
2 Align the holes in the unit (two locations on each
side) with the vehicle mounting bracket and secure
the unit with the accessory screws.
8 mm
MAX.
ø5mm
ø5mm
8mm
MAX.
T
N
T
N
T/N
T: Toyota cars
N: Nissan cars
Accessory3...for Nissan car
Accessory4...for Toyota car
3
4
¤
• During installation, do not use any screws except for
those provided. The use of different screws might result in
damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used
with excessive force during the installations.
B64-3693-00English.indd16B64-3693-00English.indd16 06.10.181:36:24PM06.10.181:36:24PM

Kenwood KDC-136 Specifications

General

Brand	Kenwood
Model	KDC-136
Category	Car Receiver
Language	English