ENGLISH
15
BLUETOOTH®
BLUETOOTH — Connection
Supported Bluetooth profiles
– Hands-Free Profile (HFP)
– Advanced Audio Distribution Profile (A2DP)
– Audio/Video Remote Control Profile
(AVRCP)
– Serial Port Profile (SPP)
– Phonebook Access Profile (PBAP)
Supported Bluetooth codecs
– Sub Band Codec (SBC)
– Advanced Audio Coding (AAC)
Connect the microphone
*
For , connect to the microphone input
terminal. (
31
)
Adjust the
microphone angle
Secure using cord clamps (not
supplied) if necessary.
Microphone input jack*
Microphone (supplied)
Rear panel
Pair and connect a Bluetooth device for the first time
1
Press to turn on the unit.
2 Search and select this unit model name (KDC-BT3
**
U/ KDC-BT2
**
U/ KDC-X3
**
/
KDC-MP3
**
BT/ KMR-D3
**
BT) on the Bluetooth device.
“PAIRING”
“PASS XXXXXX” Device name “PRESS” “VOLUME KNOB” scrolls on the display.
• For some Bluetooth devices, you may need to enter the Personal Identification Number (PIN)
code immediately after searching.
3 Press the volume knob to start pairing.
“PAIRING OK” appears when pairing is completed.
• This unit supports Secure Simple Pairing (SSP).
• Up to 10 devices can be registered (paired) in total.
• Once the pairing is completed, the Bluetooth device will remain registered in the unit even if you
reset the unit. To delete the paired device,
19
, [
DEVICE DELETE
].
Once pairing is completed, Bluetooth connection is established automatically.
•
/ / : “BT1” and/or “BT2” indicator on the faceplate lights up.
•
/ : “BT1” and/or “BT2” on the display window lights up.
• A maximum of two Bluetooth phones and one Bluetooth audio device can be connected at any
time.
• Some Bluetooth devices may not automatically connect to the unit after pairing. Connect the
device to the unit manually.
• Refer to the instruction manual of the Bluetooth device for more information.
Auto Pairing
When you connect iPhone/ iPod touch/ Android device to the USB input terminal, pairing request
(via Bluetooth) is automatically activated.
Press the volume knob to pair once you have confirmed the device name.
Automatic pairing request is activated only if:
– Bluetooth function of the connected devcie is turned on.
– [
AUTO PAIRING
] is set to [
ON
]. (
19
)
– KENWOOD MUSIC PLAY application is installed on the Android device (
8
) and [
BROWSE MODE
] is
selected (
9
).
To Next Page
Loading...
Need help?
General
