Need help?Do you have a question about the Kenwood R-1000 and is the answer not in the manual?
Details the R-1000's receiver circuit, including antennas, filters, mixers, and detectors.
Explains the Phase-Locked Loop (PLL) circuit's configuration and operation.
Details the MSM5524 IC's operation, including display drive, time correction, and input/output pins.
Shows how to disassemble the front panel and remove the RX unit from the chassis.
Details RB line adjustment and initial RX unit adjustments like BFO.
Describes adjustments for VFO output level, VCO voltage, and the clock oscillator.
Details adjustments for RF/IF amplifier stages and the IF trap coil.
Explains how to adjust the MCF (Monolithic Crystal Filter) using tracking generators or SSG.
Covers adjustments for the noise blanker circuit and the S-meter.
To Next Page
General
