770/GS/GJ-BA-defsi-0023 81
The display shows the following special codes for your
information:
O displayed in the upper right corner stands for
OFF
The balance was disconnected from AC power
(balance reconnected to AC power or power outage longer
than 3 seconds)
O displayed in the lower left corner means
standby
The display has been turned off by the
ON/OFF
key. The
balance is now in the ready-to-operate mode and does not
require warm-up.
means busy
Once you have turned on the balance, that symbol will be
displayed until you press a key. During operation, this
symbol indicates that the balance processor is still busy
processing a function and will not accept another command
to perform any other functions at this time.
1.3.4 Taring
A weight can be determined accurately only from a defined
zero point. Press the
TARE
key to zero the weight display.
You can tare within the entire weighing range of the
balance.
1.3.5 Simple Weighing (Weight Determination)
Place your sample on the weighing pan to determine the
weight. Read off the weight indicated on the display only
after the weight unit “g“ or a different unit selected appears
as the stability symbol.
To Next Page
Loading...
Need help?
General
