Kicker KM604 User Manual

5English
Wiring Configuration
We recommend using 16 gauge (or larger) wire. The
KM Speakers are rated at 4 ohms and work with
any source unit or amplifier designed to operate at
a 4 ohm load. Make sure your source unit or
amplifier is rated for 4 ohm operation. Carefully
place the speaker wire in a location that is clear of
standing water and moving components of the boat.
Connect the speaker wire to the speaker terminals.
At least two amplifier channels are needed for stereo
operation
1. Connect the speaker’s wide spade terminal to the
positive output of the amplifier channel.
2. Connect the speaker’s narrow spade terminal to
the negative output of the amplifier channel.
Pro Tip: You’re a KICKER KXM amplifier and a
few cables away from a full system upgrade that
will dominate any factory system! KICKER line of
amplifiers make it easy to upgrade to solid bass with
your existing or stock source unit. Also, ask your
dealer about KICKER Subwoofer upgrades.
Installation

Kicker KM604 Specifications

General

Brand	Kicker
Model	KM604
Category	Speakers
Language	English