Mounting
Your CO alarm is designed for
mounting onto the inside wall.
You should fix the back plate
provided to the wall first, using
the screws and rawl plugs.
When the plate is attached
locate the the slots on the
back of the alarm with the keys on the
back plate, sliding downwards and into position until the
tab clips onto the top of the alarm (see figure 1).
To remove, press the tab against the wall and lift the alarm out of the
mounting plate.
Install your CO alarm 1.5 metres from the floor.
NOTE: Your 9CO5 CO alarm is not designed for portability.
Where To Install Your Kidde CO Alarm
The following suggestions are intended to help you with the
placement and installation of your Kidde CO alarm.
• Place out of the reach of children. Under no circumstance
should children be allowed to handle the CO alarm.
• Install in a bedroom or hallway located close to the sleeping
area. Take special care to verify the alarm can be heard in
sleeping areas.
• It is recommended that a CO alarm be installed on each
level of a multilevel home.
• Locate at least 2 metres away from all fuel burning
appliances.
• Placing at eye level allows for optimum monitoring of the
red and green indicator lights, or, as a guide, 1.5 metres
from the floor.
5
Installation Instructions
Figure 1
To Next Page
Loading...
Need help?
General
