Quick Set-Up
3
Step 4
Plug the alarm into a standard, unswitched 120 volt AC
electric outlet in one of the configurations listed in step 2.
Step 5
If the battery pack has a full charge when first powered
up, you will see three eights in the digital display
indicating the alarm is warming up. After approximately 20
seconds, the first reading will be displayed. The number
on the display should be “0”. If the battery pack is partially
charged,“Lb”(Low battery) will flash every second alternating
with a “0” until the battery is charged.
Step 6
Make sure the red dot in the digital display is blinking.
Then test the unit’s operation by pressing and releasing
the Test / Reset button. Within 15 seconds you will hear 4
quick “chirps”–followed by 5 seconds of silence–followed
by 4 quick “chirps”.
Step 7
While testing the alarm, have someone else check that the
alarm can be heard easily from the sleeping areas. The
alarm should be located where it can wake you if it
alarms at night. See page 7 for complete information on
the best locations for your alarm.
Caution: Continuous exposure to the loud 85 decibel (db)
alarm at close range over an extended period of time may
cause hearing loss.
Your Kidde CO alarm is now monitoring for the presence
of carbon monoxide.
To Next Page
Loading...
Need help?
General
