8
5. Introduction, Product Features and Specifications
INTRODUCTION
This alarm detects products of combustion using photoelectric technology. Ten (10) years after the
unit is installed, this unit will automatically alert you that it is time to replace the unit. This is called “End
of Unit Life” mode. See Troubleshooting Guide. To help identify the date to replace the unit, a label has
been affixed to the side of the alarm. NOTE: AC power must be connected to obtain the full 10 year
battery and unit life.
PRODUCT FEATURES AND SPECIFICATIONS:
• Temperature: Operating Range: 4.4°C (40°F) to 37.8°C (100°F)
• Humidity: Operating range: up to 95% RH non-condensing
• Audible Alarm: 85+ dB at 10’ 3.0 to 3.5 KHz pulsing alarm, with voice message “Fire!”
NOTE: This is not a CO alarm, but it will receive and transmit a CO alarm signal (with voice message
“Warning! Carbon Monoxide”) from an interconnected CO or combination smoke/CO alarm.
• Smoke Sensor: Photoelectric
• LED Strobe
• Voice message system
• Smoke Alarm Hush® Control
• Ambient Light Sensing
• Powered by 120 V AC (60 Hz, 687 mA max) wire-in connector with sealed lithium battery backup.
• Hardwire interconnectable to other compatible alarms.
• One large, user- friendly button. (Strobe dome is the button).
• Applications: Primary Direct or Indirect and Supplementary
• Light Output: 177 Candela minimum (on axis measurement)
To Next Page
Loading...
Need help?
General
