KitchenAid KDTE104DSS0 Installation Instructions

Select UL Listed/CSA Approved twist-on wire connectors rated to
connect your power supply cord to 16-gauge dishwasher wiring.
Electrical Shock Hazard
ElectricMly ground dishwasher.
Connect ground wire to green ground connector in
terminal box.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
--_ Connect ground wire
,
o
d
I JI V_-_ _/ wire _ L_rouna
_ashe
Ground j
Remove the ground connector screw and place through the ring
terminal of the green ground wire. Reattach and tighten the
ground connector screw.
J _:
Power Cord--Connect
remaining wires
' /
)
NOTE: Do not pre-twist stranded wire. Twist on wire connector.
Gently tug on wires to be sure both are secured.
Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors.
If needed, see website for animated representation of this step.
Visit www.kitchenaid.com/electrical under FAQ tab.
Tighten strain relief screws to secure cord.
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside box. Close cover ensuring
wires are not pinched. Use 1/4"hex-head socket, nut driver or
Torx®T20 ®screwdriver and previously removed screw to secure
cover.
NOTE: Do not plug into outlet until instructed to do so.
13

KitchenAid KDTE104DSS0 Specifications

General

Style	built-in dishwashers
Color	stainless-steel
Noise level	46 decibels
Control Type	electronic
Delay Start	yes
Child Lock	no
Load Sensor	yes
Number of Racks	2
Cycle Signal	no
Water Filter	yes
Food Disposer	no
Sanitize Settings	no
Annual Energy Consumption	260 kilowatt hours
Voltage	120 volts
Current	15 amperes

Weight and Dimensions

Depth	24.75 inches