KitchenAid KDTE104DSS0 Installation Instructions

Woodcabinet:Sandtheholeuntilsmooth.
Metalcabinet:Coverholewithgrommetincludedwithpower
supplycordkit.
Option B, Direct Wire:
Helpful Tip: Wiring the dishwasher will be easier if you route the
cable into the cabinet opening from the right-hand side.
Drill a 1V2"(3.8 cm) hole in right-hand cabinet side or rear.
See "Product and Cabinet Opening Dimensions" section.
Wood cabinet: Sand the hole until smooth.
Metal cabinet: Cover hole with grommet (Part Number 302797 -
not provided).
Route cable from power supply through cabinet hole (cable must
extend to the right front side of cabinet opening). Tape cable to
the floor in area shown. This will prohibit cable from moving when
dishwasher is moved into cabinet opening.
Prepare and Route Water Lne
Helpful Tip: Routing the water line through the left side of cabinet
opening will make water connection easier.
Drill a V2"(1.3 cm) hole in the cabinet side or rear.
(copper tubing only)
Measure overall length of copper tubing for the water supply line.
8

KitchenAid KDTE104DSS0 Specifications

General

Style	built-in dishwashers
Color	stainless-steel
Noise level	46 decibels
Control Type	electronic
Delay Start	yes
Child Lock	no
Load Sensor	yes
Number of Racks	2
Cycle Signal	no
Water Filter	yes
Food Disposer	no
Sanitize Settings	no
Annual Energy Consumption	260 kilowatt hours
Voltage	120 volts
Current	15 amperes

Weight and Dimensions

Depth	24.75 inches