Name: KMART Hollywood Mirror
Brand: KMART
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Page 7 of 12

4 Assembly Method

4.1 Base

Please Note: a small amount of assembly is required and a Phillips Head

screwdriver will be required.

• Position the two side posts over the holes in the base and then from

underneath, insert the Short screws and tighten with the screwdriver.

• Centre the Mirror over the slot in the base, as shown below, and then

lower down. Push down firm until the mirror rests in the slot.

• Insert the four Long screws into the back of the mirror as shown below

and tighten.

Long

Screws

Short

Screws

Questions and Answers:

Need help?

Do you have a question about the KMART Hollywood Mirror and is the answer not in the manual?

KMART Hollywood Mirror Specifications

General