18
OPERATING INSTRUCTIONS
BATTERY PACK CHARGE LEVEL POWER INDICATOR ON THE MOWER
≥70%
45%-70%
10%-45%
<10%
= Solid light, = Flashing light, = Light is off
Mower-Overload Protection
To prevent overload conditions, do not try to cut too much grass at one time. Slow your cutting
pace or raise the cutting height.
Your mower has built-in overload circuit protection. When the mower is overloaded, the motor
will stop and the power indicator on the mower will be off. Remove the battery pack from the
mower. Check to see if grass has accumulated beneath the deck and clear it, if necessary,
then install the battery pack and restart the mower.
Battery High-Temperature Protection
The battery pack will generate heat during operation. The heat dissipates more slowly in
hot weather. If the battery becomes overheated during operation, the protection circuit will
immediately turn off the mower to protect the battery pack from heat damage. Release the bail
switch (A), wait for the battery pack to cool down, then restart the mower.
9. To Start/Stop the Mower
WARNING
• The operation of any lawn mower can result in
foreign objects being thrown into your or others’
eyes, which can damage eyes severely. Always
wear safety glasses while operating the mower
or while performing any adjustments or repairs
on the mower.
• Ensure that other people and pets remain at
least 100 feet (30m) away from the mower when
it is in use.
• The blade will continue to rotate for a few
seconds after the mower is turned off. Allow the
motor/blade to stop rotating before starting it again. Do not rapidly turn the mower off and on.
CAUTION
• Do not attempt to override the operation of the safety button (C) and bail switch (A).
NOTICE: The motor cannot be started unless:
• The side rails (M) are fully extended.
• Both handle-locking clamps (D) are securely closed.
• The handle (B) is locked into one of the three operating positions.
9
C
A
B
To Next Page
Loading...
Need help?
General
