4
SYMBOLS
Some of the following symbols may be used on this product. Please study them and learn their mean-
ing. Proper interpretation of these symbols will allow you to operate the product better and safer.
SYMBOLS DESIGNATION EXPLANATION
V Volts Voltage
A Amperes Current
Hz Hertz Frequency (cycles per second)
W Watts Power
no No Load Speed Rational speed, at no load
Alternating Current Type of current
/min Per Minute
Revolutions, strokes, surface speed, orbits, etc., per
minute
PSI Pressure Pressure is measured in pounds per square inch
Safety Alert Indicates a potential personal injury hazard.
Read The Operator’s Manual
To reduce the risk of injury, user must read and
understand operator’s manual before using this product.
Eye Protection
Always wear eye protection with side shields marked to
comply with ANSI Z87.1.
Wet Conditions Alert
Do not expose to rain or use in damp locations.
Risk of Injection
To reduce the risk of injection or injury, never direct a
water system toward people or pets or place any body
part in the stream. Leaking hoses and ttings are also
capable of causing injection injury. Do not hold hoses or
ttings.
Kickback
To reduce the risk of injury from kickback, hold the spray
wand securely with both hands when the machine is on.
Electric Shock
Failure to use in dry conditions and to observe safe
practices can result in electric shock.
Risk of Explosion Do not spray ammable liquids.
Recycle
This product uses lithium-ion (Li-ion) batteries. Local,
state or federal laws may prohibit disposal of batteries
in ordinary trash. Consult your local waste authority for
information regarding available recycling and/or disposal
options.
To Next Page
Loading...
Need help?
General
