16
9b. To remove:
a. Press the battery release button (Q) on the string trimmer. This will cause the battery to raise
out of the tool slightly.
b.
Note:
WARNING: Follow these instructions in order to avoid injury and to reduce the risk of electric
• Replace the battery immediately if the battery case is damaged.
• Verify that the switch is in the OFF position before inserting or removing the battery.
• Verify that the battery is removed and the switch is in the OFF position before inspecting,
adjusting, or performing maintenance on any part of the string trimmer.
• Read, understand, and follow the instructions on Page 7.
ASSEMBLY INSTRUCTIONS
OPERATING INSTRUCTIONS
To avoid injury:
• Do not squeeze the trigger while the string trimmer is facing up.
•
WARNING
Before each use:
• Make sure the protective guard is tightly installed. If not, tighten the guard screws.
• Before trimming, inspect the area for string, wire, branches or other material that may become
entangled in the cutting line and thrown.
10. Attaching a shoulder harness
• Rotate the harness holder (U) to the upward
position.
• Hook a shoulder harness (not included) to the
harness holder (U).
10
U
To Next Page
Loading...
Need help?
General