Kobalt SGY-A11WH User Manual

7
INSTRUCTIONS FOR ADJUSTING HEADGEAR
INSTRUCTION FOR ADJUSTING ANGLE OF HELMET
1. Loosen one of the headgear adjusting nuts (A) by turning the
nut counterclockwise.
2. Slide the angle adjustment shaft (E) to either position 1 or 2.
3. Tighten the headgear adjusting nut down by turning it clockwise.
Do not overtighten the nut as the threads may become stripped.
4. Repeat steps 1 - 3 on the other headgear adjusting nut.
1. Loosen one of the headgear adjusting nuts (A) by turning the
nut counterclockwise.
2. Move the adjustable angle regulator (D1L and D2R) to the
desired pin.
3. Tighten the headgear adjusting nut down by turning it
clockwise Do not overtighten the nut as the threads may
become stripped.
4. Repeat steps 1 - 3 on other side of headgear.
2
E
1
2
3
1
A
3
A
1
A
D1L
kobalttools.com

Kobalt SGY-A11WH Specifications

General

Brand	Kobalt
Model	SGY-A11WH
Category	Welding Accessories
Language	English