12
12. Once flushed fluid is clear, turn pressure control
knob (F) to the lowest pressure setting, and turn
off power switch. See Figure 5.
Turn prime spray valve switch (H) to spray position.
See Figure 6.
Slowly turn pressure control knob (F) to clockwise to
prime/clean position. See Figure 10.
Once motor is running, squeeze trigger and allow fluid
to run through spray system and out through the spray
gun (D) for at least 45 seconds. See Figure 12.
Once flushed fluid is clear, turn pressure control
knob (F) to the lowest pressure setting, and turn off
power switch. See Figure 5.
process, reattach inlet screen
to suction tube and turn counterclockwise to tighten.
13. Remove suction tube from spigot, clean water, or
flushing fluid. See Figure 13.
B
I
13
OPERATING INSTRUCTIONS
PRIMING SPRAYER WITH PAINT
Note: Before beginning any paint project, properly stir paint and/or strain paint
to make sure any contaminants or debris are thoroughly removed to avoid
clogging the spray tip. Check to make sure the color is correct. The pressure
release button (N) is designed to allow the user to release suction in the
system at times of an emergency. It is not intended to be used as a regular
form of releasing suction in the sprayer system.
Wear protective gear, goggles, latex gloves, and respirator or dust
mask when using equipment.
N
To Next Page
Loading...
Need help?
General
