24
kobalttools.com
DO NOT try to increase the spray coverage area by holding the spray gun further away from the surface
being sprayed. If held further away than 12-14 inches, less paint will reach the surface and more paint
will be wasted as overspray (spray that does not properly get sprayed to the spraying surface).
Proper Coverage
• Before you begin, make sure you understand the technique for proper spraying application.
• Make sure your arm is moving before squeezing and before releasing the trigger on the spray gun
as not doing so will increase the chance for paint build up or inconsistent spraying in certain areas.
Note: Practice may be needed to make sure that you are able to achieve the proper technique before
spraying the surface area you intend to paint.
areas that can easily be reached. Work from the top to the bottom in a consistent and even motion.
Once the outer edges are properly covered, begin working your way toward the middle of the surface,
remembering to spray from top to bottom.
1.
squeezing technique.
2.
overlapping the previous row by 50% to provide consistent
paint coverage through each passing row.
3. When spraying, keep arm motion movements, angle of
spraying, and speed at which you spray across the surface
as consistent as possible.
Repeat the above process until you have reached the bottom of the surface you intend to paint.
Note: When working on outside structures or where there is
an eave or overhang, properly cover the eave or overhang
before spraying the surface area you wish to paint.
When painting outdoor structures, spray horizontally. When
spraying moulding or surfaces which are uneven (siding),
Removal of any pre-spray preparation materials should only be done after the sprayed surface has had
adequate time to properly dry. Please reference your materials supplier’s recommendations on how
much time is needed for properly drying. Removal of any pre-spray preparation materials before surface
is completely dry can affect the outcome of the sprayed surface area.
Spray corners
and outer
edge first
Spray corners
and outer
edge first
Spray at a slightly
upward angle to
properly cover surface
Spray at a slightly
upward angle to
properly cover surface
SPRAYING TECHNIQUES
The spray gun should be held 12-14 inches away from the surface and held at a 90° angle from the
surface area.
12”- 14”12”- 14”
CorrectCorrect IncorrectIncorrect
X
Thin coatThin coat Thin coatThin coatHeavy coatHeavy coat
IncorrectIncorrect
Start
stroke
Start
stroke
End
stroke
End
stroke
Pull
trigger
Pull
trigger
Release
trigger
Release
trigger
12-14”12-14”
CorrectCorrect
To Next Page
Loading...
Need help?
General
