12
WARNING: To avoid injury, do not connect this
miter saw to a power source until it is completely
assembled and adjusted and you have read and
understood the operator’s manual.
INSTALLING THE MITER HANDLE (FIG. 1)
● Thread the miter handle (E) into the hole located
at the front of the miter saw (A).
INSTALLING THE DUST BAG (FIG. 2)
●
Squeeze the metal collar wings on the dust bag (C).
●
Place the dust bag neck opening around the
exhaust port on the miter saw (A) and release the
metal collar wings.
NOTE: To empty the dust bag, squeeze the metal collar
wings and remove from exhaust port. Open zipper on
underside of bag and empty into waste container.
IMPORTANT: Check frequently and empty bag before
it gets full.
WARNING: Do not use this saw to cut and/or sand
metals. The hot chips or sparks may ignite sawdust
from the bag material.
ASSEMBLY INSTRUCTIONS
C
A
1
A
E
2
To Next Page
Loading...
Need help?
General