INSTALLATION INSTRUCTIONS
12
4. Tighten strain relief nut. Place a athead screwdriver into raised notch and tap screwdriver with
hammer until tight.
Tighten strain relief screws to hold power cord securely. Replace the pressure switch cover (knob
must be in the same position as when removed to sit correctly in place). Tighten the pressure
switch screw with Phillips screwdriver. Check that switch is in the OFF position. Follow break-in
procedure from owner’s manual.
ASSEMBLY INSTRUCTIONS
FILTER
Install intake lters on pump. Filter styles
may vary.
4
Strain Relief Nut
Strain Relief Screw
1
To Next Page
Loading...
Need help?
General
