KODAK CAROUSEL® Slide Projector 5
Operation
Loading the Slide Tray
KODAK Slide Trays are available in 80- and 140-slide capacities. Use a
140-slide tray if you use thin-mounted slides (1/16 in. / 1.6 mm) and need
the larger capacity. Use an 80 cpacity tray if any of your slides have thick
mounts (1/8 in. / 2.5 mm).
Note: Do not attempt to project slides mounted with sticky or loose tape.
Place the tray over the center post of the projector. Align the "0" slot with the
gate index; the tray will drop into position.
If your 140-slide tray does not drop easily, secure the lock ring, invert the
tray, and align the index hole with the index notch. Slide and hold the tray
release latch in the direction of the arrow, and turn the bottom plate until the
index hole and notch align. Then release the latch. If you use an 80-slide tray,
rotate the metal plate on the bottom of the tray until it locks into position.
140-Slide Tray 80-Slide Tray
To Next Page
Loading...
Need help?
General