8
Shutdown Instructions
Step 1
Turn the engine to
the OFF position.
Step 4
Disconnect the high-pressure
hose from the water OUTLET.
Step 2
Turn OFF the water supply.
Step 6
Engage the gun safety-lock.
Step 5
Disconnect the garden hose
from the water INLET.
CAUTION: Failure to discharge the residual
pressure could result in personal injury due
to discharge of high-pressure water.
Step 3
Discharge residual pressure
by pressing and holding the
gun trigger until no water
comes out the nozzle.
Thermal Protection Valve
Your pressure washer is equipped with a thermal protection valve, located at the base of the pump.
If the engine is left running for an extended time with the gun closed, the pressure washer will dump
water into the atmosphere through this valve.
NOTE: Always shut the engine OFF and engage
the gun safety-lock when the pressure washer
is not is use.
CAUTION: Never allow the pressure washer to
run for more than 3 minutes with the gun closed
and the engine running. Prolonged operation in
bypass mode can result in damage to the pump.
To Next Page
Loading...
Need help?
General
