Figure 41 Worn Impeller
10. Inspect the coverplate and gasket for corrosion and/or damage. Replace components as necessary.
11. Lubricate the gasket with silicon grease and attach the gasket and coverplate to the seawater pump housing.
12. Open the sea cock.
13. Check that the generator set is OFF.
14. Reconnect the generator set engine starting battery, negative (-) lead last.
15. Reconnect the power to the battery charger, if equipped.
16. Start the generator set and check for leaks.
17. Stop the generator set and repair leaks or replace damaged or worn components.
To Next Page
Loading...
Need help?
General
