Kohler Command CH13 User Manual

11.17
Section 11
Reassembly
11
3. Install the air cleaner base onto the mounting
studs. Connect the breather hose to the fitting of
the rocker cover. Secure with the clamp.
4. Install a new gasket, the spitback cup/collector
plate/or air cleaner bracket as equipped, and
secure with the hex nuts. Torque the hex flange
nuts to 9.9 N·m (88 in. lb.). See Figure 11-57.
Figure 11-58. Adjusting Governor.
2. Install the governor spring in the appropriate
hole in the governor arm and throttle control
lever, as indicated in the chart. Note that hole
positions are counted from the top of the lever.
See Figure 11-55.
Install Air Cleaner Base and Air Intake
System, Adjust Governor Lever
1. Connect choke linkage to the carburetor choke
lever. See Figure 11-56.
2. Install a new air cleaner base gasket onto the
mounting studs.
Figure 11-55. Installing Governor Spring.
RPM should be checked with a tachometer.
Figure 11-56. Connecting Choke Linkage.
Figure 11-57. Installing Air Cleaner Base.
5. Adjust Governor Lever
a. Pull the governor lever away from the
carburetor to the wide open throttle position.
b. Grasp the governor cross shaft with a pliers
and turn the shaft counterclockwise as far as
it will go.
c. Tighten the hex nut on governor lever
securely. See Figure 11-58.
Air Cleaner
Base
Choke
Linkage
eldIhgiH
MPR
ronrevoG
.oNeloHreveL
r
eveLelttorhT
.oNeloH
008363
00635 1
00434 1
00233 1
00032 1

Kohler Command CH13 Specifications

General

Brand	Kohler
Model	Command CH13
Category	Engine
Language	English